To remove the OLD brush head, grip the brush head tightly on the rubber sides, just above the neck of the toothbrush with one hand. Pull the brush head straight off of the brush with the other hand, then wiggle back and forth to loosen – don’t twist. The brush head fits snugly to prevent it from coming off, so you’ll need to pull with a little bit of force to remove it.

To replace the NEW brush head, align the brush head so the bristles face the same direction as the buttons on the handle. Firmly press the brush head down onto the toothbrush handle until it stops firmly in place.

1. Gently twist bottom of Glow On The Go device counterclockwise until dots line up, then gently pull to remove bottom.
2. Remove cap from Whitening Pen and insert into bottom of device until the bristles are exposed at the top.
3. Replace bottom of device by twisting back on and continue twisting until the whitening serum from the pen becomes visible — this will require several twists.
4. Press power button to turn on the blue light.
5. Brush serum across the top row of teeth while focusing on areas with the most amount of staining.
6. The device will beep after 30 seconds to indicate it’s time to move to the bottom row of teeth. TIP: Extra twists of the device may be required to release more whitening serum.                                  
7. The device will beep again after 30 seconds signifying the completion of the treatment.
8. Wipe off or rinse brush tip under warm water after each use and replace cap. Rinse brush tip well.
9. Replace cap while blue light is still on to sanitize.

The device will automatically turn off once it is done sanitizing.

To charge:
Use included USB cord and a wall plug. The charging indicator will light up orange and will turn off once charging is completed.

Add to your toothbrush and brush as usual. The American Dental Association recommends brushing for 2 minutes, twice a day.

FLIP – applicator over from paper sleeve and reinsert it with the applicator pointing outwards.

POP – the applicator between thumb and index finger. With the applicator pointing down, squeeze firmly until the inner tube pops and is saturated with the whitening formula. Make sure the applicator is pointing down and fully saturated – almost to the point of dripping – before applying.

ERASE – directly to each tooth’s surface in a circular motion. Avoid sensitivity by targeting away from the gum area. Continue to squeeze the applicator to move the whitening formula as you go!

After applying, wait 20 minutes before you rinse, eat or drink.